My weight reading does not start at zero with an empty vessel or locks at a high weight level. My contractor said something about linear correction. What exactly is linear correction and what are some indications of a poor linear correction?
My weight reading is fine until I reach weights of 32,767 lbs. After this, it rolls over to a negative number. Why isn't my instrument reading correct above 32,767 lbs?
I do not get a TGERR on my HI 2151/20WC display but still lose parameter settings and/or calibration data. I do not receive this message even though the units have a SMM 1205 with firmware 0650-0069. Is the battery inside the SMM unit weak?
I have a blank display and found the fuse was blown. When I install a correct replacement fuse, it also blows at power up. Why am I blowing fuses on my HI 2151/30WC, HI2110WI, or HI 2151/20WC?
Can I calculate the expected Millivolt reading of my scale? I want to place a test weight on the scale and know what the expected signal Mv load cell output increase will be.
I have vessels and tanks with large mixers that are breaking the bolts on the Legacy HI LPS series load cells. Is there a problem with the installation or the bolts that could be causing this?
